Lucky Ladybug Birdhouse

This colorful Lady Bug Birdhouse Design is sure to get lots of attention wherever you display it!

Hang this unique project from a tree limb using wire and an eye screw or mount on a fence or tree trunk using our Flush Mount Hangers (available below). The bottom is hinged for easy clean out when nesting season is over.

This fun project is easy to make from our full-size pattern and step-by-step instructions. Uses two brass plated hinges (#BHNG1) and Plastic Eyes (#PE301) available below. (16" tall)

More Info

Dimensions:
14" tall

Wood:
One 1X10 x 84" long pine board.

Tools:
Table saw or circular saw and band saw or scroll saw with a smooth non-chipping blade, hammer, drill and 1-1/2" and 1/4" dia. drill bits.

Hardware:
Nails - One box, 3D 1-1/4" long, finish.
Hinge - Two 1" x 1-1/16" brass plated (1 pack #BHNG1).
Eyescrew (optional) - One 5/16" I.D. (#EYE3).
Flush Mount Hanger (optional) - One 1-3/4" x 1-1/2" (#FMH).
Screw - One #8 x 1-1/2" long, flat head.
Plastic Eyes - Two (#PE301) Copper Pipe - 1/4" dia. soft copper, 24" long.

Supplies:
Transfer paper (#CARB), pencil & clear tape.
Sand paper - medium & fine grits.
Wood Glue - exterior (#GLUETB3).
Wood filler - non shrinking, fast drying for wood flaws.
Paint brushes - 2", 1" and fine detail.
Craft Sand - Approximately 1 cup, fine grain.

Paint:
White water base primer (#PRIMQT) for a base coat and the following suggested colors of Delta Craft paint:
2083 - Fire Red
2506 - Black
Black outdoor enamel Spray Paint.

Sealer:
High-grade, non-yellowing, semi-gloss UV protected project sealer (#POLYQT) for outdoor protection.